Answer Posted / surendra
it is the unit luminous intensity per unit solid angle of
the area
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
what is plunger and what's the use of it in motor alignment?
Why does amplifier gain reduce?
how much GROUND & NEUTRAL VOLT maintain in data center.
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
what is the difference between Central Battery System and UPS in applications and uses? and why UPS suitable for Computers and central battery for emergency lighting?
What is a system?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
The sodium vapor lamp is not glows when it is connected a distance of 5 meters above from gearbox, why ?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What is electrical diversity factor in electrical installations?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
Why Stabilising Resistor used in REF circuit ?
