What is basic difference between Soft Starters And VFD
drives?
- 19 Answers
- 46856 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / rajnish
according to me soft starter is only to reduce the kick
current for safety of motor and to its connected parts.
where as in VFD we can not only control the speed of motor
but can control the starting speed ( acceleration) and
stopping speed(deacceleration)of motor.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Can u Explain about the electronic trivector meter and the use of data converters in them?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
Define rise time.
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
what is the difference between torque induced and torque load?compare them with respect to dc motor?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
what is booster? and how it is connected in a circuit?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
explain remenance . differentiate high remenance type ct & low remenance type ct
Please send 110 kv sb station full single line drawing(sld)
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
Explain Energy and Power signals?
