what is the difference between electrical & electronics
Answer Posted / lipu
Most of the time we saw that electrical system deals with
AC(Alternating current).
And electronics system deals with DC(direct current).
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is Load sharing of Transformer ?
what is distribution board?
trasnfarmaer core make
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
Why do we perform an open-circuit test and short-circuit test on the transformer?
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
How many kw will suply from one db
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
What is Antipumping Function & If we have C.T how we find the Ratio ?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
Earth leakage relay basic knowledge principle
What is the efficiency during maximum power transfer?
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
Keywords: Die, Card, Coin, B/N 2 To 12