What is mean by discrimination of circuit breaker ?
- 1 Answers
- 3269 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahesh
It means CB should be able to asess whether fault is in its
protection zone or not
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
Any one can explaination about calibration with rotating sub standards?
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
What is the difference between Droop vs Isoch Control?
why constant voltage transformer should be start without load? and if started then what will happen?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
What is the suitable transmission voltage?
what is p.s impedance measurement test in earthing transformer?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
How do we calculate the Out put voltage of generator, after the excitation is being given?
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
Draw the equivalent circuit of crystal oscillator?
