What is micromotion transmitter? What is the porpose of
using this transmitter?
Answer Posted / gk3000
I think you are talking about the Vendor name "Micro
motion" which manufacture the Coriolis meters.
This instrument measures the mass flow rate of fluid by 2
parallel vibrating tubes.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
key phaser where is use and work
what is the different between deflection type measurement and null type measurement in RTD?
Calibration procedure for water rotameters
What is instrumentation instrumentation engineering?
how to calibrate corollaries (Mass flow meter)?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
Yokogawa CENTUMVP R6.09 unable to download to Engineering Station with ExaOPC R3.75
The issue is when I try to download the common project section to the Engineering Station (STN) from the HIS in System View, it is unable to connect. The error displayed is:
WARNING: Could not connect to equalize destination. (7001)
Retrying. Number of retries = 0/1
ERROR: LdXopsLoadMain: connect error 10060
ERROR: Processing terminated due to connection error. (7002)
Equalization end with errors. STN0149
---- ERROR = 2 WARNING = 1 ----
Background:
>Updated the ExaOPC software on the STN from 3.60 to 3.75
>STN operating system is Windows Server 2008 R2
>HIS operating system is Windows Server 2016 Stanard
Solutions attempted include:
>Ensuring all IP addresses are correct and all networked devices can be pinged.
>The ability to ping a device using its host name from another device (
Positioner usage.
Draw block digram for well head from well to shipping pump?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
what is instrument philosophy
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
what is the minimum power (P=VI)to produce a spark?
why orfice is not used for main steam flow calculation