Interested to Buy Any Domain ? << Click Here >> for more details...
If you don’t have coal, salt and copper, then how would you
earth your connection temporarily at a campus site?
- 2 Answers
- 5111 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
then we put every day water
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
how to calculate the conductor size for certain KV transmission line and distribution line?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
How to run a three phase motor into single phase........
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
How much dc volt applied in cathodic protection system?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
List the power rating of any 5 important electrical appliances used in houses.
what is the difference b/w pvc cu conductor and cu breaded wire..?
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
Disadventage of cable-gland earthing if any ?
what is the difference between RMS & TRUE RMS VOLTAGE
