beam top main reinforcement(25mm) was drilled off by
mistakely when making drill hole for dummy columns. any one
can give useful information for this issue or related code
or websites.
- 3 Answers
- 4891 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashok kumar
Best method to fill up this hole by Epoxy grouting then go
after one/two hour for prescribed place of drill. it very simple
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
What are the important hardware systems used for cad?
which red: used in roof teping, then use only cement
a solid steel rod length 2m dia and 20mm vertically hangs from celling and has a collar firmly atteched to it. above the collar an annular rubber washer of 40mm th. having stifness k = 5n/mm is placed. determine maximum stress in the rod caused by mass of 5 kg falling through a height of 1.2m.
What expenses counted in contingencies and how much it is in related to built-up area of the building.
what is the criteria for the finalisation of pavement thickness in road project?
How to cal. The weight of hollow pipe?
what is the calculation of raw material for 0.35cum of m-15
In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.
from where ican get sample papers for CET-delhi 2012
density of crush sand & crush stone or grit powder
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
what is the cost of rcc roof casting of 400 sq. ft. in kolkata
What is the crank length in the slab?
how clculate excavated or backfilling quantity by simpson's rule
How cracks in concrete can be avoided?
