Interested to Buy Any Domain ? << Click Here >> for more details...
Which softwere is required to communicate the S7-300
processor
- 4 Answers
- 8464 Views
- I also Faced
- E-Mail Answers
Answer Posted / soumya
SIMANTIC-S7-MANEGER IS USED
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
can you send remote seal interface level transmitter calculation steps for oil water saperator.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
all types instrumentation questions want
what is effect of specific gravity in differential level transmitter , explain formula related with this .
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
what is sliding spool valves?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
What are different types of orifice plates?
how to measure oxygen which methods are using?
