Answer Posted / tanvir
15 kva dg set can use for 25 amp 3 phase load with
calculation of power factor 0.8.
| Is This Answer Correct ? | 9 Yes | 10 No |
Post New Answer View All Answers
What is different bewteen low or high impedance busbar protection scheme
why industry prefer ht motor instead of lt motor.
What is conventional thermal current (Ith)
Can any body tell me the different types of LT cables & their application.
What is frantic effect?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
What do you mean by pull of electromagnet?
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
What is the difference between a Root Locus plot and a Bode plot?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
