Interested to Buy Any Domain ? << Click Here >> for more details...
WHY THE FREQUENCY IS 50 HZ IN INDIA.CAN WE USE SOME OTHER
FREQUENCY.IF SO WHAT IS THE RANGE AND WHAT WILL BE THE
EFFECT IN PRESENT POWER SYSTEM IF WE CHANGE THE FREQUENCY
AS YOU SUGGEST ?
- 32 Answers
- 58853 Views
- L&T, MCL, I also Faced
- E-Mail Answers
Answer Posted / vijendra joglekar
It is standarad frequency in india.
Electrical equipment made by the manufacture only for
certain frequency can not be used for other frequency.
In some cases it is made to be used for both frequencies
and in that case they specially mentioned on the type plate:
50/60 Hertz.
Example battery charger for laptop computer: on the type
plate itself is mentioned:100/240volts 50/60 hertz(which
means any voltage between 100 and 240 volt plus can be used
on either 50 or 60 Hertz.
Why you can not use other frequency:
because internal current goes up and might this up faster
deteriation of the insulation of wiring,which cause
shortciruit and this may lead fir,which can burn down your
house
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
What are books to be referred for KPTCL exam?
What is the Diff. btw Manule Pull Station & Manule Abort Station Switches used in FM200 System??
what is per unit calculation?looking for simple and strong explanation thk u
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
if sf6 gas low in gis what will happen
Fantio of tranformer
The screw thread commonly used for transmission of motion is one of the following types of threads
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
What is the difference between vector surge relay (78) and Pole slip relay (98G)
hai iam arunkumar. i have applied for an section enginner in rrb. i want lat 5 years solved question papers. if u have please sedn it to arun30682@gmail.com
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
What is critical disruptive voltage?
What are the types of control system?
