what is ifference between PFR ,MFR and batch reactor?
- 9 Answers
- 56920 Views
- BARC, IOCL, I also Faced
- E-Mail Answers
Answer Posted / rajesh kumar bhagat
PFR- plug flow reactor is one where latrel mixing is allowed
but longitudnal mixing that is along the length not allowed.
composition changes along the length.
MFR- mixed flow reactor, composition throughout the reactor
will be same and all calculation will be done on output
composition.
Batch reactor- reactant will placed in reactor and let them
react and after some time or after completion of reaction take
it out.
| Is This Answer Correct ? | 57 Yes | 5 No |
Post New Answer View All Answers
What are some of the consequences of an undersized kettle type reboiler?
Explain the some guidelines for sizing a psv for a fire scenario on a vessel in a refinery service?
X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.
hai....i am chandrika. if anybody having test questions for HAL,HPCL,ONGC,IOL...PLS SEND THE QUES WITH SOLVED ANSWERS TO ME TO MY MAIL ID chandrismiles@yahoo.co.uk
Why in a continuous plant for a Hot standby screw pump system the interlock for auto starting of the other pump ( when the running pump stopped suddenly) is given with header pressure only? why not with flow rate or current of the pump?
When an expansion is joint needed on the shell side of a shell and tube heat exchanger?
Where barrel pump use?
Name some common problems associated with dense phase pneumatic conveying?
Can asphalt be recycled to form a useful product?
What are some good estimates for heat transfer coefficients for coils in tanks?
Dear guys we adding hypo at climax plant and that water is inlet to DM plant so with hypo water that can affect my resins of cation and anion. if it is affect life of my anion and cation so what kind of steps should be take.
What do we use carburizing/nitriding chemicals for?
Corenuts technology interview questions
Explain what are the disadvantages of using gear pumps?
what is the hearth and arch pressure in furnace?
