Answer Posted / sudheer868
As the function of C.T is to step down current and measure
it as all small meters can measure upto 5A it is rated at 5A
Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
What happen when change order of CT in GIS feeder?
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
Give some differences between open loop and closed loop control systems.
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
Do you need any help with FEWA Electrical Supervisor exams?
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
surge tank, hrc fuse, earthing transformer, firm power objective type
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?