Answer Posted / srabon1059
ACB(Air circuit breaker):
1.ACB provide over load,under voltage and short ckt protection.
2.mainly used in industrial are.
MCCB(oulded case circuit breker):
1.Provide over load ,short ckt protection.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the causes for the failures of sandwich type (Al) busducts?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
What is meant by reverse polarity and how it can be fixed?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Explain about Leakage Test.
Fantio of tranformer
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
Write the force balance equation of ideal spring element.
what is residuel magnetism. and how order lead acid batteries for 24 volt. emergency lighting system.
"TRANSFORMER MODELING AND ANALYSIS" MEANS WHAT AND WHICH TOPICS U READ IN THIS
How many types of probe used in cro?
how to operate and maintenance of 1500 kva diesel generator set
I am having a 42KW 3 phase electrical heating furnace, heating element is 80/20 nichrome material, my connections is made in such a way that 2 star connection compromising 2 coils per phase so totally 12 coils, shall if i use it unbalanced star condition (instead of 2 group of 3 phase or 1 group of 3 phase, connecting 4 phases of 5 phases) what will be the consequences and is it acceptable?
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
