Interested to Buy Any Domain ? << Click Here >> for more details...
When measuring the Insulation resistance of a motor winding
(winding to earth) using a megger meter, Applied
voltage(1000V) was automatically reduced to 500V. and the
measured insulation resistance values are also very low (in
Kohm range) Can anyone give me a reason???
- 3 Answers
- 7496 Views
- I also Faced
- E-Mail Answers
Answer Posted / raghavendran.r
The reason for the fall in supply voltage could be because of the fact Insulation has started conducting heavily as mentioned that insulation resistance is also poor.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to find ampere on ht side for selection of cable size ???
Why hydropower stations are preferred solution for meeting peak loads in grids?
What is the use for cable entry in control room?
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
how much GROUND & NEUTRAL VOLT maintain in data center.
Why is water motor not taking the pressure? what is the problem?
Why High voltage are generate noise ?
What is meant by Load Encroachment in OHL Feeder Protection?
How we calculate DC inducation moter Amp? Sir pls give me formula......
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
How many double suspension hardware fittings are required on a double circuit transmission tower?
When MICC cables used ?
what is the mechanical safety of DG ?
What is mean by hot and cold loop testing?
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
