what is the difference between two wire transmitter and 4-
wire transmitter
- 3 Answers
- 19208 Views
- I also Faced
- E-Mail Answers
Answer Posted / george s
In the two wire transmitter one wire shall be the power
wire and the other wire will be the return wire(4-20mA)
Where as in the 4 wire transmitter (2 wires for power
supply and the other two for the 4-20 mA output)
| Is This Answer Correct ? | 30 Yes | 19 No |
Post New Answer View All Answers
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
what is the importance of CV in the control valves? how it is calculated?
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
how can leve transmetter calibate in feild .and also put cv and flow plz .....
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
What is the principle of capacitance type level transmitter?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Describe the function of Accumulator into the Pump
draw the block diagram of a level transmitter ?
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
What are different type of instrument cable
components of control circuit belongs to control valve
what is the working principal of pribe
