what is the need of representing AC power in sinusoidal
waveform? why not in square or rectangular etc...
- 8 Answers
- 8621 Views
- Lanco, I also Faced
- E-Mail Answers
Answer Posted / khs kumar
I Agree with Mr. Virendra J Joshi.
In case of Square Wave the voltage will not vary with time. There will be only two stages one is saturation point and the other is cutoff point. This can be happened only in DC voltage. When the power is on then it will reach to saturation point and be stable unless until it is off. Once it is off it will reach to cutoff point and be stable unless until it is on. One completion of on stage and offstage is called one complete cycle.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is physical distance of isolator to VCB in 33/11kv sub stations
orifice sizing how done, checking & selection
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
CPC cable .PVC \1C....I want to get sure that type is flexible indoor or to be install on trench. please advice .thanx :)
I am shobana from Chennai. I am having my personal interview on 19th Dec at Chennai.kindly mail me the questions to mail id shobana.shanthi@gmail.com
why induction motors are rated at 0.8 power factor.
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
how do you test tachos and servos
What are the advantages and disadvantages of the dc motors?
I am having a 42KW 3 phase electrical heating furnace, heating element is 80/20 nichrome material, my connections is made in such a way that 2 star connection compromising 2 coils per phase so totally 12 coils, shall if i use it unbalanced star condition (instead of 2 group of 3 phase or 1 group of 3 phase, connecting 4 phases of 5 phases) what will be the consequences and is it acceptable?
how we provide neutral earth on synchronising panel as per electrical standards?
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
What is lifting power for 1 wb/m2 and 1 A magnet?
Difference between transition and diffusion capacitance
