we touch other end of the tester supply, why do not get
shock?
- 7 Answers
- 13221 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / rajeev.p
The other end of the tester,supply came through a
resister.There for the voltage is reduced by resistor.
| Is This Answer Correct ? | 11 Yes | 4 No |
Post New Answer View All Answers
define the non synchoronism of synchoronous machine in general g or m??
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
Define cut-off rate?
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
how solar power plant energy meter multiplication factor
Difference between transition and diffusion capacitance
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
what is rating boiler
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
What is Bolted fault?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
What is use of starter and choke in tube light
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
What is dielectric loss?
