why do we generate sinusoidal ac?can we generate some other
waveforms by alternators?
Answer Posted / yogesh raste
In case of Alternator, It rotates from 0 degrees to 180
degrees and then from 180 degrees to 360 degrees. In doing
so it cuts the flux lines do to which an emf is produced in
an alternating manner.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Why are iron cores in transformers made laminated?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
Explain about technical and non technical losses in distribution system?
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
Why to keep capacitor bank off while generator running.