Answer Posted / raghavendran.r
rotor angle or load angle stability denotes the angular
displacement between stator and rotor speeds.It is directly
proportional to the speed of the m/c ie the load connected
to the Generator.If the Angle is beyong tolerable limit,
the system will come out of synchronism.
| Is This Answer Correct ? | 27 Yes | 4 No |
Post New Answer View All Answers
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
Difference between Earthing Truck & Earthing trolly for HT panel
Instrument connected to a single phase supply
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
What are the different losses In a de mac1une'! t.xplam
Who many reason of ignition fail ?
what is auto re-closer?
How will polarity test of Dy5 Transformer ?
What are the three major categories of error?
Is RTCC panel needs any control supply.
can anyone show me how the 3 phase power is supplied to socket outlets?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
