What is fault level? How can be calculate the fault level?
- 1 Answers
- 3528 Views
- I also Faced
- E-Mail Answers
Answer Posted / raghavendran.r
Max short ckt current can be found out by formula...
Isc = fault MVA/[Nominal Sys. Voltage]
fault MVA = System MVA/[p.u.Impedance]
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is the relationship between current&voltage in practical purpose ?
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
Why is better to have a minimum ceiling voltage of 250% than 160%?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Explain the term parallel path in dc machin ?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
Can we convert off line transformer to on line transformer
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
what is the best method of grounding in 30 MW generator?
What is the formula to calculate a three phase alternator
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
