in 5 mva transformer 33/11 kv s/s what rating of capacitor
bank is required & what is the fourmula for rating
- 6 Answers
- 13356 Views
- I also Faced
- E-Mail Answers
Answer Posted / bala.a
Generally we are using capacitor bank at down stream
only . ( consumer end ) so will provide capacitor bank only
for 11/ .433 KV T/R
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How can calculate the rating of a alternator for a given specific load with formula
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
some basic standard questions on transformer.
1.4 What is meant by CT knee point voltage and how would you determine it
what is vA rating and class of a ct.
what is a pulse transformer? how rise time of pulse changes when ever the voltage changes?
SUTIABLE FOR ohm's law super conductor
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
what is the working principle of a DG Set, Alternator, & exiter
How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
