why the tapping of transformer on ht side??????
- 12 Answers
- 38723 Views
- CTS, OPTCL, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / jay
there are many appx reasons
1. ht is placed outer side of transformer.
2. if tappings are on lv side the number of turns will be
less so if we want to regulate o/p voltage it will vary
with a large difference while if we use tap at high voltage
it will have more number of turns so we were be able to
regulate voltage even in small difference.
3. its current rating is low.
| Is This Answer Correct ? | 35 Yes | 3 No |
Post New Answer View All Answers
what is the difference between interconnection and intraconnections in the circuit diagrams
What is the function of the circuit breaker failure relay?
send me all basic electrical question and answers
What is the necessary condition for stability.
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
send me any model test paper of clerical post of state bank of india.......
how test transfomer(3 phase75kva) by megger
what is the solution for meger test failed the MV cable?
State the frequency for rc phase shift oscillator?
what is th basic difference between a d latch time line and a d flip flop time line???
is there any role of power factor with frequency variation? and how we can manage the frequency variation?
Define noise?
How does zener phenomenon differ from avalanche breakdown?
how unidirectional torque is produced in DC motor?
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
