what is the technical diffrences of mccb and acb
- 11 Answers
- 20176 Views
- TransWorks, I also Faced
- E-Mail Answers
Answer Posted / jeet
i also want add little facts like you for BCH
ACB - available above 800 A in BCH make
MCCB - available from 10 A to 4000 in BCH make
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
whate is the meaning of balance/unbalance,in stabilizers type
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
Haw to check conductivity of budbar
How the capacitance og capacitor volatage transformer is decided?
What are motor generator sets and explain the different ways the motor generator set can be used ?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
What is resonant peak?
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
What is meant by analogous system?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
what shoud be strength and weakness to impress interviewer????????
defination of lines
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
