Answer Posted / syed shafeeq ahmed
EXCHANE OF INFORMATION BETWEEN TWO MEDIA OR BODIES IS TERMED
AS COMMUNICATION
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
all types instrumentation questions want
What is instrumentation measurement?
ORP sensor working principle?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
Explain the working of an enraf level gauge.
Calibration procedure for water rotameters
Draw symbols of the following :
can you provide me full detail about instrumentation in ONGC??
Explain why plc require in analog input 4-20amp & 0-10 volt?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
