why transformer rating in kva and motor rating in kw
- 11 Answers
- 14582 Views
- I also Faced
- E-Mail Answers
Answer Posted / rahul khurana
In transformer there are tho typw of losses core losses and
copper losses. core losses depends upon voltage and copper
losses depend upon current. there is no windage losses in
transformer whereas in motor it occurs.
so, in conclusion there is no any factor in transformer
which relates with power factor so the rating of
transformer is in KVA instead of KW.
| Is This Answer Correct ? | 12 Yes | 4 No |
Post New Answer View All Answers
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
1.why we are using blocks in withoutgaplightning arrester 2.why we ar using bushing in withoutgap lightning arrestor
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
hi can anyone pls tell me the eee interview core questions asked in l&t
Explain (in simple ) - root mean square. whats its role in electrical fundamandal.where its used
iam preparing for rrb section engineer post in electrical branch.suggest the right textbook for my reference.fromwhere i will get the previous q.papers?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
How DC earth leakage currents can be reduced ?
What is d main advantage of using double circuit 3 phase transmission ?
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
What are test signals and their significance?
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
why the neutral point in connnection oscillates?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
