Interested to Buy Any Domain ? << Click Here >> for more details...
why control circuit voltage always chooses to be 110v and
220v? and in where it is 110v and 220v? and in where it AC
and DC?
- 2 Answers
- 6375 Views
- I also Faced
- E-Mail Answers
Answer Posted / m.kumaran
the control voltages are 110V and 220V.because the form factor is 1.11 and it is derived from RMS value of induced voltage and average value of induced voltage,so we need RMS value=form factor * average value.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
In dc ckt. 24v or 110v, which one is more efficient and why?
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
BSNL TTA EXAM QUESTION
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
What conditions are required for transformer to operate at low frequencies ?
what things to be considered when designing UPS
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
what is the difference between rectifier and converter and commudator?
what is the effect of higher value of GD???
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
