Answer Posted / siva
The Power transformers inner and incipient faults are
identified by the Bacholtz relay.but the Faults which are
occurring outside the transformers are detected by the
Distance Protection relays.
the Distance protection relay operates on the principle of
Differential relay,and it is acted with reference from the
CT's and PT's Which are Connected on both the End of the
Transformer.
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
What are the advantages of thermal power plant?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
what is mind in cable
What is meant by coupling capacitor?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
How Diesel Generator start ?
Where voltage are high and current to be interrupted is low the breaker preferred is:
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
is it true there's a big difference in using Cummins or Denyo...especially power output or leakage
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
