Is there any interfacing sofware to build communication
between a PC and ER300P model L&T make trivector meter via
RS485 port which is available in the meter and is there any
data acquisition card available to store the acquired data
from the meter into the system
- 12 Answers
- 18654 Views
- I also Faced
- E-Mail Answers
Answer Posted / pearl george
u can write in the meter using write code using modbus. jus chek the location of the power using modscan or sum silmple software n then u can write in dat location with a loop or sumtng at ur will..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are different type of instrument cable
what would be the minimum flow rate that we can measure on rotameter..?
How to check vortex flow meter is in good condition while we do not having calibration setup?
what about your moleg in pogrees with company
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
plz tell me clearly about PID.."when v have to change I value,D value,GAIN??
for oil & gas industries which zone is normally preferred? why? give its example?
how do calibrate the valves.. with clear manual
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
How is flow measured in square root?
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
How to convert milliampares into flow??
