Interested to Buy Any Domain ? << Click Here >> for more details...
how fan speed decrease or increase by using regulator?
thank you
- 3 Answers
- 7418 Views
- I also Faced
- E-Mail Answers
Answer Posted / apoorv
fan speed is controlled by varying the resistance. if the resistance increases , the fan speed decreases, and vica-versa
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
what shoud be strength and weakness to impress interviewer????????
The simple way of finding the leakage quantity and % in compressed air distribution system
Define what is difference between fuse and breaker?
Is there any standard guidelines/Criteria to design NGR/NGT.?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
v/f drive basic princeple
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
is there any phase difference occurs while primary and secondary side mutual induction occurs?
What is process of anneling transformer core
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
