Hi all of you,
Actually this is interview qe? but i did,t do explain it
completely so please give reply recently and completly Ans,
what is sub-interface and inter-vlan ? And How to implement
it on cisco router & switches and also which series router
switches supported please write..........
- 2 Answers
- 5031 Views
- Cisco, I also Faced
- E-Mail Answers
Answer Posted / jitendera
hi
This is jitendera here i am trying to give answer hope this will help u
sub interface-sub interface is no thing it is a virtual interface so that on single interface of a router we can assigns multiple ip and it is very important in inter-vlan routing
how we can create it
route(config)interface fa0/0.1
this command is used to make the sub interface
remember the concept of inter vlan routing there u will get the command like
#interface fa0/0.1
#encapsulation dotq/isl 2
#ip address 192.168.100.10 255.255.255.0
#interface fa0/0.2
#encapsulation dotq/isl 3
#ip address 193.168.100.1 255.255.255.0
this is the command for intervlan routing.here what u are looking that on single interface fa0/0 i am putting multiple ip as 192 and 193 series and i can put more
this is the concept of sub interface
i am assuming that u know what is vlan now what is intervaln?
as you know that 2 different vlan can not communicate now i want communication then what will u do
this step is called intervlan
and whole process is called intervlan routing.command i have written above
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is Route Poisoning?
Explain how many broadcast domains are in switch?
Define mac address?
Mention what is the difference between tcp and udp?
How many types of ospf configuration?
What is the command for change serial cost?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
What are some standards supported by the Presentation layer?
What is the virtual channel?
Which ipsec rule is used for the olympia branch and what does it define?
Explain what is formula of hold down time of eigrp protocol?
Explain what is route poisoning?
What are the steps of conversion for data encapsulation?
When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
