what is skin effect? why is it absentin dc system
- 22 Answers
- 41691 Views
- I also Faced
- E-Mail Answers
Answer Posted / kunal varshney
Skin effect appears in conductors carrying Alternative
currents. as its name shows, current flows through the
surface rather than through the whole cross sectional area
of the conductor. it happens because of electromagnetic
effect of AC. Due to it inductance of conductor is more at
the centre and it decreases as reaches to surface of
conductor .thats why in AC current flow on surface of
conductor.
as we know that reactance is zero that is the effect oo
inductance is zero therfore their is uniform resistance in
& on the surface thats why skin effect is absent
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
What is meant by stator? What is meant by rotor?
why magnetising curve not start with zero voltage?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
compare between starting charactristics of synchronous motor with those of 3Q Squirrel cage induction motor
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
Pls explan the OLR setting in VCB at HT yard
What are the essential characteristics of signal flow graphs?
neutral earth resistance testing is it possible for transformer while in load condition
What is difference between Sample test and Routine test in safety standard?
Iin ESP why positive is grounded ? why not negative ?
What is George phenomena to start the synchronus machine?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
