What happened when a three phase induction motor work on
two phase supply.9
- 6 Answers
- 8093 Views
- I also Faced
- E-Mail Answers
Answer Posted / ken shirke
This condition is called single phasing.In this case motor
draws more current from remaining two supply lines.Torque
developed is reduced since T is directly proportion to
v2.There will be a sever vibration.Motor will run if load
is small.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
State the frequency for rc phase shift oscillator?
what are the interview question asked in wind mill about electrical
what is laser diodes?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
what is DRP panels?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
On 400 amp factory load how kvarh capacitors provide
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
what is earth pit , how we can measured it, what earth rods reference
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
i want wipro vlsi placement pattern please send me
