what is the difference between delta-delta, delta-star
transformer???
- 3 Answers
- 17905 Views
- I also Faced
- E-Mail Answers
Answer Posted / virendra
Delta - de;ta transfomer is used at Gnerating station or a
receiving station for Change of Voltage , generally it is
used where the Voltage is high & Current is low.
where Delta star is a distribution kind of transfoemr where
from secondary star neutral is taken as a return path .
this configuration is used for Step down voltage phenomina
| Is This Answer Correct ? | 26 Yes | 0 No |
Post New Answer View All Answers
Post possible questions for Power Factor Panel FAT / SAT
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
WHY THE COLOR OF OUTDOOR TRANSFORMER IS BLUE ONLY???
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
where solid grounding and where grounding through ngr done and why?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
Testing report of Earthing of 3.15 MVa PTR.
Why have to use copper cable for local isolator to motor ?
what is a pilot wiring and whys that called a pilot wiers
is it possible to have dc motors on single chip
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
what is the difference between skin effect
why h parameter are called as hybrid parameter?
