HOW SKIN EFFECT REDUCE THE CROSS SECTION OF THE CONDUCTOR
Answer Posted / appar
in this situation current is flowing only the outer most
part of the conductor,that time current innerpart will get
heat it will act as a resistance and cross section of the
conductor will be less.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How the annunciator works ? How to do its wiring
How to calculate the phase to phase clearness of HT /// LT bus bar?????
why current is constant on d.c?
what are the safety measures of induction motor?
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
What is the formula to calculate the size of Aluminium and copper cable?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
what are the installation procedure of high voltage power transformer,CT,CB&PT?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
How are load losses and no-load losses measured at site in a DG set?
Why does the rotor rotate?
What is the physical significance of phase.. i.e. what is exactly the meaning in layman's language.. 1 phase, 3 phase etc ???