What is the tolerence limit between neutral and earth in
230 V AC System?
- 7 Answers
- 9148 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / saleem khan
Clearance between neutral and earth should not be less
than 20mm.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is use of starter and choke in tube light
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
Why temperature rise is conducted in bus bars and isolators?
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
why any centrifugal blower draw more current in starting. consider id fan and fd fan?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
in 132kv substation CRT means
a simple c++ program to calculate simple interst with its data members as private
What is the most accurate way of testing ELCB?ELCB is better than RCD?
physical identification of HT & LT panel
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
How 3 phase invertor works?
