Whats meant by trivector meter where it is connected at the
substation?
- 20 Answers
- 105633 Views
- GPIL, Infosys, Jakson, L&T, Secure Meters, I also Faced
- E-Mail Answers
Answer Posted / aneesha
trivector meter is a divice that measure the amount of
electrical energy supplied to or produced by
residence,bussiness,or machine.The trivector has automatic
self diagonostic check.In the absence of supply,it provides
even minute reading.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
What is the maximum percentage voltage drop (vd%)for a motor control center
What is the Nyquist criterion regarding control systems?
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
pls someone send me sample question papers along with the key.thanks in advance
1.what is the reason for transformer and lightning arrester blast in 33kv system
for 750 kw LT load what will be the ht kva
how does commutator convert a.c to d.c?
The windings of a transformer are divided into several coils, because?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
