What is a PID controller and how can it to applied to our
everyday life?
- 4 Answers
- 23397 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajith294
At first you should understand what is the controller.
A controller is the device in a closed loop, that compares the measured valve (actual valve) with the desired valve and calculate the out put manipulated variable. Then The time (T) responds is determined by P,I,D
P: manipulated variable our put is proportional to the system deviation. that means variable only present if there is any system deviation.
I: manipulated variable is continues to increase, the system deviation decreases. this process continuous until system deviation is zero.
D: Differential compound evaluate the speed of change of the system deviation.
so if using the PID controls, we can control the flow to our desired valve at a very short time.
Best Regards
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
what is maxdna ?. explain about the software details.
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
how to tune siemens sipart electro pneumatic positioner..plz tel me..
why orfice is not used for main steam flow calculation
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
principle of automatic votage regulator
Give Detail information about plc,dcs,and scada system?
Capacitance, resistance ( colour coding ), parallel & series circuits.
What do you know about gail?
what is stroke check for field instument transmetter's & AOV's
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
