Answer Posted / j venkteswaran
VFD is for controlling the speed of the motor by adjusting
the frequency and voltage.
If voltage decreases frequency will decrease,if voltage
increases frequency will increase this is the general
principle as V/f ratio
| Is This Answer Correct ? | 12 Yes | 7 No |
Post New Answer View All Answers
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
what is meant by surge? what we called for high currents?
What is an iron loss or core loss pi?
what is the meaning of neutral displacement ???
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
why surge protectetor work explain with the help of circut diagram?
what is the voltage between earth & neutral in 3 phase electrical connection.
How shall i select the value of capacitor or inductor in a system?
What is an order of a system.
explain all the classes with example
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
design a 3 bit synchronous and asynchronous counter using T- flipflop
