Answer Posted / dinesh patil
Some of the Liquid componets (suppose A & B) are difficult
to seperate under normal tempreture & pressure or due to
low boiling point difference (when the mixture is
Azotropic) So requirment of extractive distillation raise.
In extractive distillation solvent component (Suppose C)is
added in such a way that it preferably extract only one of
component among A or B and after ward distillation
operation can be done.
Is This Answer Correct ? | 16 Yes | 3 No |
Post New Answer View All Answers
Is it advisable to cool a fin fan by spraying demineralized water on it?
What is carbon sequestration?
hi sir/madam i need placement paper of last years of DRDO in chemical sream...... send me the question paper as soon as possible on my email address praveen.zone@gmail.com
X is strong but has a very low density (1% of traditional earth materials.) and hence light weight. It is a recyclable material. The compression behaviour of X is strain rate dependent. Higher strain rates result in higher initial modulus and higher compression strength. It can also withstand unlimited number of cycling loading provided the repetitive loads are kept below 80% of the compressive strength. The internal structure of the material includes air-traps which make it poor heat conductor. X is non- biodegradable and chemically inert in both soil and water. Most acids and their water solutions do not attack it; however strong oxidizing acids do. Solvents which attack X include esters, ketones, ethers, aromatic and aliphatic hydrocarbons and their emulsions, among others. It does not support bacterial/fungal growth as well .It also has significant acoustic properties and effectively reduces the transmission of airborne sound. X is combustible and should not be exposed to open flame or other ignition sources. Combustion products are carbon monoxide, carbon dioxide, water and soot. Long-term exposure to sunlight causes yellowing and a slight embrittlement of the surface due to ultraviolet light. X is able to withstand the rigours of temperature cycling, assuring long-term performance.
For amonia manufacturing process if pressure, temperature would be increase over optimum level what would be happen?And what steps should be taken?
Explain the strategies acquired to cure tube vibration and exchangers in a shell?
hi can anyone tell me some technical questions asked in iocl
What could be a possible cause for sudden foaming in a cooling tower?
At what temperature does water have maximum density?
What is screen analysis?
What is the basic difference between dispersion & distribution in any polymer blend or alloy??
Explain the reasons of removal of particles from effluent gas?
What are flameless oxidizers?
What are some good strategies for curing tube vibration in shell and tube exchangers?
What is pneumatic conveying?