What happened when we give 2 phase supply to a 1 phase
equimpent. It's effect on equipment's efficiency and life?
- 5 Answers
- 6760 Views
- I also Faced
- E-Mail Answers
Answer Posted / asmita
Actually there is no 2 phase supply.Even if u take any 2
wires i.e.R & Y for giving 2 phase supply it will act as
single phase supply.1 phase will act as phase n other as
neutral.
| Is This Answer Correct ? | 3 Yes | 11 No |
Post New Answer View All Answers
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
Why do you have to use Protecion relay with the function MTB ( Mechanical Trip Button ) for electrical system.
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
what is the meaning of 5% droop or 7% droop in AVR?
Explain the different regions in frequency response?
How can you sized or estimate the ligthning arrester current rating?
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
can we synchronize star system generators with delta system generators?
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
what is a bus riser in power system and why it is used
What is the formula of frequency ?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
