what is a mapping in plc & dcs
- 1 Answers
- 11417 Views
- Arctern, ARM Cement, I also Faced
- E-Mail Answers
Answer Posted / ravinder tanwar
Mapping is the process of assigning the addresses to the
controller for I/O integrity for e.g in GE fanuc PLC if we
have to assign a single address for AND combination of two
inputs then we simply connect these two inputs in series
and assign a single address for for combination of these
two inputs means (%I0001---%I0002----------%M0003)
Here I in input from field and M is memory mapping address
assigned for combination of these two inputs
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
Emergency Shutdown Systems/ Plant Shutdown System.
Manipulation of dead wt. tester double piston type.
Why humidity limit is 30 to 55 % for raw material storage?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
What is the diffrence between digital signal processing and discrete signal processing?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What are the type of bonnets in the control valves?
How many interlocks at turbine? Plz explain briefly
why we r opening HOT BYPASS valve during startup of a compressor?
how to turbine speed measurement?
what are the values of fuel flow rate in various places in boiler.
Explain PID controller tuning & any one method used for it.
i need some objective type questions in instrumentation
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
How u measure the massflow in orifice flow measurement techniques
