Pure inductive ckt takes power from AC when
1. Applied voltage and Current increases
2. applied voltage and current decreses
3. voltage decreases and current decreases
please justify
Answer Posted / sanjay tiwari (electrical engi
As per my opinion first option is correct because inductor
takes power from AC ckt up to max voltage.during this it
takes up max current.when the voltage decreases it returns
the power in toto.In a full cycle the power consumtion is
zero.
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
What is the principal of motor?
What is the difference between alternator and generator?
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
what is positive , negative & zero equivalent system resistance
What are the parts in a inverter?
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?
which of the following elements is not present in stainless steel
what is the write prosidure of stringing of 8meter pcc pole.
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
What is the phase relationship between the primary and secondary voltages of a transformer?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
What is cathode ray oscilloscope (cro)?
CBCT selection
how to calculate micom relay earth falt time and current sertting
What will be result if we connect LT votage to the terminal of HT motor?