what type of protection used below 132KV feeders
Answer Posted / p.mahesh goud
1.over current protection
2.earth falth protection
3.Distance protection
4.shart circuit protection
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What happen Grid EARTH plat got cut.
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
How to calculate Number of Earthing Pits....???
how we will deside the high voltage value
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
Explain cos(theta) and Sin(theta)
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
What is Bolted fault?
what is the circulate the diesel in DG in side pls tell parts name and picture with circulate the diesel
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
Why is the air gap between the pole pieces and the armature kept very small?