how many types of thermocouple cable are? give the name of
each type.
- 1 Answers
- 6059 Views
- Fabco, I also Faced
- E-Mail Answers
Answer Posted / kannan
There are there types of cables is in the Thermocouple.
1.Bare Thermocouple wire.
2.Duplex Insulated Thermocouple Wire
3.Metal Sheathed Thermocouple Wire
1. Bare Thermocouple wire is without any insulation.
normally it is sold on a spool and ordered as a pair. usage
is typically for making a small thermocouple in
applications requiring special considerations.
2.Duplex Insulated Thermocouple Wire
Duplex Insulated thermocuple wire is probably the most
common type of thermocouple wire. The type of thermocouple,
insulation, and size are all some of the parameters
considered for the application.
3.Metal Sheathed Thermocouple Wire.
Metal sheathed Thermocouple wire is thermocouple wire that
is surrounded by insulation material, typical magnesium
oxid, and enclosed in a metal sheath. A key feature of this
type of wire includes the ability to withstand vibration,
high temperatures and pressures.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
Manipulation of dead wt. tester double piston type.
what is SIL 1 2 3
what would be the minimum flow rate that we can measure on rotameter..?
what is the calibration procedure for magnetic flow meter @ onsite
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
What is Cavitation in a control valve?
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
why we are using magnet for calibration of gas detector?
Explain bernoulli’s theorem. State its application.
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
How r the calculation of process line mpm.
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
Tell about your IFFCO plant visit.
