what is the difference between electrical & electronics?
- 4 Answers
- 7624 Views
- JSW, I also Faced
- E-Mail Answers
Answer Posted / yaser riaz
In electrical the current flows only through the copper wire.
& in Elx it flows thru semiconductor material like diode,
transistor,scr etc
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
How to size Air Circuit breaker (ACB)? What is the most important factors?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
reason of diode failure in alternator
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
What is A check, B check, C Check & D check for a diesel Generat
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
why the projects getting loss?
what is per unit calculation?looking for simple and strong explanation thk u
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
What is non-minimum phase transfer function?
what are the sample questions asking to the test cunducting for electrical superwising lisence test?
what is the acceptable limit value for Desolve Gas Analysis/
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
