Answer Posted / saravanan.p
According the Faraday's Law,Whenever current carrying
conductor cuts the magnetic field, dynamically EMF(Electro
Magmetic Force)is induced.This induced EMF produce the rate
of change of flex.
This will helps the rotate the generators.
Also, Generators operating as the principles of Fleming's
left hand rules.
| Is This Answer Correct ? | 3 Yes | 9 No |
Post New Answer View All Answers
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
what is proper capacitor placement? How to evaluate capacitor size?
What is super thermal power plant? and how it will differ from normal thermal power plant
Difference between a pilot wire and a normal conductor?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
can we find the inductance of a induction motor?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
Y phase plates are used in transmission line??? what is there need???
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
What is the difference between voltages or potential difference? And what are they?
sir i have cleared the apti test of EIL held on 15th march and my interview will be in new delhi on 2nd june.i will be very much helpful if u help me regarding the type of interview questions comes at EIL.(URGENT.........PLZZZZZZZZZZ...............)
what are symmetrical and non symmetrical components in electrical installation.
is IS says that neutral should be brought to switch box. and this one is a recomended practice
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
