Interested to Buy Any Domain ? << Click Here >> for more details...
difference between isolater and circuit breaker?
- 7 Answers
- 13751 Views
- Adani, I also Faced
- E-Mail Answers
Answer Posted / balram raturi
major diffrence is that isolator operates on no load &
circuit breaker operates on load
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
Why squirrel cage motor can only use with low starting loads ?
our industries ht line so power fluctation(once drop of power please rectify causes
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
How servo stabilizer works.
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
What are locations arc protection relay is fixed.
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
is IS says that neutral should be brought to switch box. and this one is a recomended practice
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
how ceiling fan worked?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
What is the difference between cylindrical-type and sandwich-type winding?
what is strip power factor?
