why low pressure side of the turbine is connected to the
alternator and not the high pressure side??
Answer Posted / vamshikrishna
to counteract the large axial thrust developed on the
tg(turbine generator) shaft, because of the impingement of
the high pressure, high temp steam on the turbine inlet
side( at high pressure side), we place the alternator on low
pressure side.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
Define closed loop control system.
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
what r the checklist while installing a 380 kva DG set
What happens to voltage when current through the inductor is constant?
What does a Bode plot tell you?
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
What do you understand by avr?
which metal is use in shunt
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
what curve and rateing would you use for a three phase 0.75kw motor?