if you short the any 2phase(R,Y,B),why fuse get blown?
Answer Posted / vasudeva rao
two pase gets shorted means (L-L fault) in this fault phase
currents are very high
Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
how ceiling fan worked?
What is open loop and control loop systems?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
salam,hi, i need to know what the spesification of 300amp msb...
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
What is electrical grounding?
How many types of colling system it trformers?
sail kaott diploma ece ke interviw me qus.kis parkar ke aate hai aur G.S me kya puchate hai kya sameedyaan me kis parkar ke qu.puchate hai
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what is transient enclosure vltage , very fast transients, very fast transient over voltages
what is earth fault relay 64T, why it is used in main Incomer and neutral CT of Transformer.
What is q factor?