Answer Posted / yadvinder singh
Electronics and communication for me was one of the
interesting and challenging branches. i wanted to know
about the PCB designing and thats why i chose electronics
and also communication plays an important role in day to
day life.CCTV cameras are very useful these days.thats all
because of electronics.
| Is This Answer Correct ? | 12 Yes | 6 No |
Post New Answer View All Answers
What are the disadvantages of pwm control?
What will be the call flow in case user doesn't answer the call
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
Explain the effect of if in radio receiver?
Describe transducer ei pickups in instrumentation and control engineering?
i done m.e communication system degree. i like to study new degree. which course is to choose. i selected m.sc applied psychology, m.sc e&i. is this suitable for me or say some suggestion to do some course.
sir/madam, i've applied for the post of section engineer. i shall highly be obliged if you could help me out with some sample papers.
What is meant by input power factor in controlled rectifier?
hello sir, could u plz send me a sample placement paper for hpcl trainee engg exam..(electrical stream)...hoping to hear from u at the earliest
What is meant by bidirectional or half-wave ac voltage controller?
what are the advantages of using a voltage follower amplifier?
i cleared the written xam. for the post of atc now what i am going to prepare for the interview plz.guide me i dnt wanna loose this organisation bcoz its my dream company
compare the delay in sending x-bit msg over k-hop path in ckt switched nw nin lightil loaded packet swithed nw. the ckt setup time is s per hop,the packet size is p bits n data rate is' b' bps under what condition does packet nw have lower delay?
What are the advantages of pwm control?
What is meant by the temperature coefficient?
